Positions: On/Off

Disconnects the battery safely, to eliminate any power draw from the battery when vehicle or boat are not in use.

Removable side plates on four sides

Isolates 1 battery pack.

UV stabilized bakelite vapor-proof housing - Built to last in marine conditions

4 mounting screw holes (mounting screws not included)

Vapor Tight & ignition protected

Important: Engine must be stopped before selecting OFF; this is to protect the alternator.

Great for your boat, caravan, RV, 4x4, show car, trailer, winch power cable, and more

Extra Heavy Duty - Rated at 1250 Amps momentary, 275 Amps continuous @ 12V DC

2-Position: ON and OFF positions

Can be used with 8V up to 50V DC systems to isolate and secure the electrical system

Disconnects the battery safely, to eliminate any power draw from the battery when vehicle or boat is not in use

Compact size, sleek modern appearance, sturdy and durable

Patented contour link system, allowing it to be a standalone unit, or linked together with other similar switches

Rotary dial has a spring-loaded keeper to lock the selected position

UV stabilized construction - Built to last in marine conditions

Easy to install - Comprehensive wiring diagram and installation instructions included

2 copper terminal studs with nuts and washers

4 mounting screw holes

Does not include mounting screws

Max.Volt (V) 50
Amp Draw (A) 275
Max Amp Draw (A) 1250
Switch Position 2
Packing Size 78x78x80 mm
N.W/GW 0.20/0.30 kg
 
Operation and Installation Instructions
Product Features:
*Continuous rating: 275Amps DC
*Intermittent rating: 455Amps DC
*Cranking rating: 1250Amps DC for 15 seconds
*Maximum Voltage: 50Volts DC
*Operation: Manual On/Off
*Operating range 8 to 50 Volts DC
*Ignition protected
*Stud Size: 2*10mm(3/8")
*Copper studs and nuts
Operation indication
Rotate the knob anticlockwise to the off position, electric circuit is cut off in the position. Press the knob and continue to rotate clockwise to the position "on" ,electric circuit is connected.
Cable entry:
The back and side panels are removable to allow access for cables and links.
Modular joining:
The 2 Position Battery Switch can be joined together using the supplied pegs. Two pegs are supplied with each switch.
Mounting:
The 2 Position Battery Switch can be either flush or recess mounted (56mm,05.2mm 0.2" hole
Warning:
The terminal should be taped or covered when the switch is mounted in such a way that the terminals are exposed.
Do not turn the switch off when the engine is running.Always stop the engine before switching to off position.
It is important that the negative for this unit is taken from the same battery that the 2 battery switch is isolating. Failure to do this will cause the unit to work erratically. Only one negative must be supplied to each unit for correct operation.


4404826-1

PushAuction