ITEM DESCRIPTION

SILANOS Part Number: 902340
GERMAC Part Number: G300
ADJUSTABLE RATE CHEMICAL DOSING PUMP 0-3.0 LITRES PER HOUR

This fixed price listing is for 1 x Dosing Pump as shown in the item picture below.

Genuine Germac dosing pump as shown in picture below, Germac dosing pumps are used by various dishwasher and glasswasher manufacturers. This 230v pump is adjustable from 0-3 lph. This unit has 2 push fit type spade connectors at the rear for mains voltage. Compression nuts accept standard 4-6mm tubing. All germac pumps are boxed in original retail packaging and contain fitting instructions. Spare pinch tubes and other model Germac pumps are available in our ebay shop under the Germac section.

Manufacturer: GERMAC 
Type: G300 
Control: frequency control 
Pump rate: 0-3.0l/h
Supply: 230 VAC 
Application: detergent 
Hose connector: 4x6mm
Hose type: thermoplastic 
Dimensions: 67x72x101mm

PLEASE NOTE: Chemical dosing pumps are not supplied with any warranty, if you have a fault with your existing pump then you need to establish what caused the pump to go faulty before replacing it with the new one, you may have an underlying fault that has led to the failure of the pump and if not rectified could cause the same fault with the new pump. Parts should always be diagnosed and installed by a suitably qualified person, if incorrectly installed, over run or allowed to run dry they will suffer irreparable damage, for this reason we cannot offer any warranty on dosing pumps.

Please note that liquid dosing capacity is for guidance only and can vary depending on several installation factors such as tube length, liquid viscosity etc. Rinse aid pumps are fitted with silicone tubing and detergent pumps are fitted with santoprene tubing.

If you require any other spare parts or accessories for your appliance visit the GERMAC section of our ebay shop. Please visit our ebay shop to see our huge range of catering parts.

All of our parts are sent out same day from our own warehouse stock

If you have any questions please do not hesitate to contact us.

We do advise that any parts are diagnosed, installed and tested by a suitably qualified engineer.