This 5 pack of MonkMakes Protoboards are designed to make the creation of one-off projects and prototypes as simple to make as possible by:

1. Using the same layout as a 400 point ‘half’ solderless breadboard.

2. Adding component footprints on the side of the board for connectors and a relay that doesn’t fit straight onto the breadboard. These are unpopulated so just add the parts you need for a particular project.

3 Adding component footprints on the board for a linear voltage regulator to add a power supply.

4. Add longer breadboard rows at the bottom of the board for modules that use 2×4 or 2×5 pins such as the ESP01 or NRF24 modules.

5. Solder jumpers to allow supply rails to be connected to a power supply