APPLICATION GUIDELINES

We STRONGLY recommend that all shirt prints are applied by heat press (this service is available from most t-shirt printing stores).

A household iron will not apply the nameset correctly and will cause damage to the nameset and/or shirt. This is because an iron does not keep a constant temperature or constant, even pressure.

Do not heat longer than advised otherwise this can cause the shirt colour to run through to the nameset.

We cannot accept any responsibility for damage that may arise due to incorrect application.

With new shirts we recommend that it is washed and dried thoroughly before applying a nameset.

We recommend that you do not wash your shirt for at least 24-48 hours after applying the nameset. Always wash the shirt inside-out and on a low temperature (30C). Air dry only.

Outer layer to be applied first following the guidelines below. Allow to cool completely. Then repeat the process for the inner layer.

• Make sure the heat press is clean before applying the nameset.
  
• Pre-press your shirt between 3-5 seconds at 160C to remove any creases or moisture.
  
• Position the letters and numbers carefully onto the football shirt in the correct position.
• Cover the nameset with a Teflon sheet, silicon sheet or equivalent.
• Apply the heat at 140C for 10 seconds at medium/firm pressure.
• Allow print to cool slightly and slowly peel off the plastic cover.
• If the name and/or number do not fully stick, stop peeling, recover and repeat the application process for a further 5 seconds.
  
  
  ANY PROBLEMS PLEASE CONTACT ME BEFORE LEAVING ANY FEEDBACK.
  
  Thank you for your custom.