When in use, the discharge needle must be placed on the balance ring (the arc can easily hit the coil)

Can only play square wave music, burn ordinary music

1. The product cannot change the power supply voltage and power supply without authorization,

2. It is strictly forbidden to connect wires

3. Please operate carefully according to the requirements of use

Product parameter

Voltage: AC110~220V

Weight: 1.5 kg

Size: 90 * 90 * 200m

Voltage: 220v discharge voltage above 200kv

Current: 2-5A

Ordinary drsstc needs to be connected to multiple power sources, but it also needs to be connected to optical fiber lines and ground wires. Ordinary players may not be able to fully understand or operate at 01:30, resulting in product damage or improper use.

      Our product is simple and the whole operation is very simple. Only one socket is needed to use a connector. There is no optical fiber cable and no grounding wire. It can be said to be the simplest operation among similar products.

It can be used directly without a grounding wire, which greatly facilitates the display of the students in the teacher's class and the purchasers who live on the upper floor without a grounding wire.

No need to use multiple power sources at the same time, only one plug can be inserted into the socket.

There is no optical fiber connector and no optical fiber cable, which reduces the product cost and increases the use feeling.

The arc length of the product exceeds 20cm, and it supports music effects. It can directly play square wave music. The arc will change with the music, and there will be different rhythms and sizes.

The volume of the whole product is small, only 1/2 as large, and the product is not as high as the two foams, so it is easy to carry.

Instructions for use

1. First insert the aviation plug into the Tesla base, and then tighten the outer ring nut to prevent loosening

2. Place the discharge needle on the top of the product equalization ring, the top can extend 2 cm

3. Lay the cable flat, do not overlap or knot, do not hang the cable

4. Finally, turn the potentiometer counterclockwise to the lowest point

5. Just plug in the power

6. When the indicator light is off, it is in music mode: you need to put your phone or other player in the playing state, and connect the audio cable to the audio port of the knob and the audio port of the phone

6. The indicator light is always on, it is the normal mode, and the knob can be adjusted to adjust the arc size

7. Turn the potentiometer to 0 before closing

 Shipping list:

1X DIY music Tesla coil SSTC high frequency generator ignition lightning 110V~220V