Mount a FLIR VUE , Sequoia Multi spectral or any type of GoPro style auxiliary camera like a Session on top of your Parrot Disco series.  GoPro buckle mounting allows maximum camera flexibility (110g limit)

Weights:
Top Mount Disco 50-65g
Bottom Mount Disco 50-80g (depends on configuration)
Typical mounting with fasteners for 1 device 8-14g

1-Includes adaptor to accept any GoPro style mounting buckle (see photos) Sequoia and FLIR VUE

2- If you need a power pak for camera such as FLIR VUE or Parrot Sequoia it can be attached to the optional bottom mount which has 5.5 inches of mounting area (see my Ebay ad Parrot Disco Bottom Camera Mount-GP-Fusion-Sequia-FLIR with or w/o EVO SS Gimbal ) or if you place under cowling.

(Attom Tech Ultra Compact 5000-mah Dual USB Outputs Super Slim Power Bank on Amazon is ideal for this use)


NOTE: You will not need to modify your Disco body with this mount however it has a 110g limit
You will need to adjust the Disco CG (center of gravity) for your camera combination

Adaptors for Parrot Sequoia and FLIR VUE included
Sequoia requires a top and bottom mount since it has a camera and sunlight component

DISCO NOT INCLUDED

(Custom mounting available send requirements for review) 

COPYRIGHT © 2020 alienconcepts incorporated

Multiple units are available 

MADE IN THE USA

General for All Mounts

We are constantly updating based on field use reports . As a result photos and instructions and components may change
at any time.

Disclaimer

We offer no guarantees  that a mount will perform up to your expectations since there are too many variables.
Use best practices for safe flying at all times . If unsure check with the FAA drone rules and regulations online.
We assume no responsibility for any damage or injury because of the addition of one of our mounts.

Payload Location and Clearance

When mounting payloads verify against recommended weights and sizes for your drone in manual or
contact manufacturer

If you mount anything on top of the mount make sure it has prop clearance a simple checking method is listed next:

1-Place your drone with props on and look down from directly above make sure
you have clearance with nothing protruding outside of the drone main body envelope into prop space

2-If you do have payloads in the body envelope or you are unsure make styrofoam size model and affix it with double stick
or velcro. Manually move through its full range and make sure there is no interference with the props.

Safeguards
Use a safety lanyard on your mounts. This is one I use : Amazon

MIZUGIWA Stainless Steel Lanyard Cable Tether Safety Wire for Loss Prevention 2 Loops w/Quick Release Ring & Rubber Coating 12" Set of 10