TOP Mount a FLIR VUE, Sequoia Multi spectral or any type of GoPro style auxiliary camera  like a 360 Fusion or MAX on TOP of your DJI Inspire 1 series . Rear mount accepts the same devices as needed. Both mounts are included in price .

NEW Long rear mount is 3/4" longer to handle larger (longer camera). Mount goes from the rear up to the downward vision sensors.

Weights:
Top Mounts I1 or I2 50-56g
Bottom Mounts I1 or i2 15-20g
Typical mounting with fasteners for 1 device 6-10g

Note: Both Mounts are Included Top and Long Rear mount  save 20% over individual mounts

Sequoia requires a top and bottom mount since it has a camera and sunlight component


This is for top and rear mounting on a DJI Inspire 1 Series 

1-Includes adaptor to accept any GoPro style mounting buckle (see photos)

2- Includes front drop down GoPro adaptor for lighting or other accessory (see photos)

3- Includes GoPro Shorty Grip adaptor (see photos)

4- If you need a power pak for camera such as FLIR VUE or Parrot Sequia it can be attached to the top mount which has 6 inches of mounting area or you can add one of Rear Bottom Mounts for attachment.

5- Includes new long rear mount for larger attachments and the top mount.

6- We offer a optional mounting frame for the EVO SS when used with the GoPro Hero 8 Black search for


DRONE NOT INCLUDED


Mount is cross bolted into frame and requires no modification all stainless steel attachment hardware included. Manufactured out of high grade PLA

This mount is not a replacement for the standrad DJI front mount camera however you could use as your only camera if you do not have a front camera.


COPYRIGHT © 2019 alienconcepts incorporated

Multiple units are available 

MADE IN THE USA

General for All Mounts

We are constantly updating based on field use reports . As a result photos and instructions and components may change
at any time.

Disclaimer

We offer no guarantees  that a mount will perform up to your expectations since there are too many variables.
Use best practices for safe flying at all times . If unsure check with the FAA drone rules and regulations online.
We assume no responsibility for any damage or injury because of the addition of one of our mounts.

Payload Location and Clearance

When mounting payloads verify against recommended weights and sizes for your drone in manual or
contact manufacturer

If you mount anything on top of the mount make sure it has prop clearance a simple checking method is listed next:

1-Place your drone with props on and look down from directly above make sure
you have clearance with nothing protruding outside of the drone main body envelope into prop space

2-If you do have payloads in the body envelope or you are unsure make styrofoam size model and affix it with double stick
or velcro. Manually move through its full range and make sure there is no interference with the props.

Safeguards
Use a safety lanyard on your mounts. This is one I use : Amazon

MIZUGIWA Stainless Steel Lanyard Cable Tether Safety Wire for Loss Prevention 2 Loops w/Quick Release Ring & Rubber Coating 12" Set of 10