OVER 350 NOW SOLD IN THE UK - THE ORIGINAL ITEM OF THIS TYPE. 

BEWARE OF POORLY MADE CHINESE COPIES !! 

IN SOME CASES I CAN MAKE CUSTOM VERSIONS, SO PLEASE ASK. IF I CAN HELP I WILL !! 

IMPORTANT- PLEASE READ ENTIRELY:

THIS ITEM IS FOR USE ON HONDA CRF250L OR CRF250 RALLY MODELS FROM 2017 ONWARDS (INTEGRAL TACH0 WITH SPEEDO), HONDA CRF300L OR CRF300 RALLY MODELS. 

THESE MODELS HAVE A FUSED (10A) AUXILIARY POWER TAKE OFF AS STANDARD, WHICH IS SWITCHED ON / OFF WITH THE IGNITION. THE POWER TAKE OFF MAKES FITTING ACCESSORIES RELATIVELY STRAIGHTFORWARD.

THIS KIT WILL BE SUPPLIED COMPLETE, AS SHOWN IN PICTURE 1. THERE IS A TWIN USB SOCKET (5V X 1.0A AND 5V X 2.1A) WITH A MOUNTING KIT FOR EITHER 22MM HANDLEBARS OR MIRROR POST / BRACKET FIXING, PLUS SMALL SCREWS FOR FASCIA PANEL MOUNTING. THERE IS ALSO AN IN - LINE PLUG SO THE USB SOCKET CAN BE DISCONNECTED TO MAKE ROUTING OR FEEDING THE CABLE THROUGH A BULKHEAD EASIER.  

THE SOCKET HAS A SEALED ON/OFF SWITCH ON THE TOP OF THE CASING, A RED L.E.D. 'POWER ON' INDICATING LIGHT, AND A RUBBER CLOSURE TO KEEP WATER AND DIRT OUT WHEN NOT IN USE. 

THERE ARE ALSO ADDITIONAL FLYING LEADS WHICH CAN BE USED FOR WIRING IN OTHER ACCESSORIES AS WELL AS THE USB SOCKET.

PLEASE NOTE: IF THE FLYING LEADS ARE NOT USED, THESE MUST BE ADEQUATELY TERMINATED AS THE RED LEAD WILL BE LIVE WITH THE IGNITION SWITCHED ON.

ALL CONNECTIONS ARE SOLDERED, WATERPROOF AND CLOSED WITH HEATSHRINK SLEEVE. OCCASIONALLY I MAY USE HIGH QUALITY ELECTRICAL TAPE FOR COSMETIC PURPOSES - THIS IS NOT PART OF THE WATERPROOF JOINTS.

FITTING:

ON THE CRF250L (2017 ON) AND CRF300L, THE O.E. AUXILIARY SOCKET IS BEHIND THE HEADLIGHT, INSIDE A RUBBER SHROUD ON THE RIGHT SIDE OF THE BIKE (PICTURE 6). IT'S USUALLY BLANKED OFF WITH A DUMMY PLUG WITH SMALL GREEN SEALS (AS IN PICTURE 7). ON THE RALLY MODELS THIS IS LOCATED ON THE LEFT SIDE OF THE BIKE BEHIND THE FRONT FAIRING, USUALLY TAPED TO THE MAIN LOOM.

THE CONNECTING PLUG FITTED TO THIS ASSEMBLY WILL BE SUPPLIED CORRECTLY CRIMPED AND SEALED (ALL INTERNAL SEALS FITTED), WITH COLOURED FLYING LEADS (RED = POSITIVE, BLACK = NEGATIVE / EARTH). THE LEADS ARE RATED WELL ABOVE THE MAXIMUM CIRCUIT CAPACITY, WHICH MEANS THAT ADDITIONAL ACCESORIES SUCH AS HEATED GRIPS CAN BE FITTED AS WELL AS THE USB SOCKET - PROVIDED THE  MAXIMUM CIRCUIT LOAD OF 10A IS NOT EXCEEDED.

SIMPLY REMOVE THE FACTORY FITTED DUMMY PLUG AND CONNECT THIS ASSEMBLY INTO THE O.E. SOCKET. 

THE FACTORY DUMMY PLUG CAN BE REMOVED BY SQUEEZING A LITTLE TANG ON ONE SIDE THEN PULLING THE CONNECTION APART.  YOU WILL BE ABLE TO SEE WHERE THE TANG IS, ON THE REPLACEMENT PLUG.

ANY QUESTIONS PLEASE ASK-I'M HERE TO HELP !