Attention: Only oil, transmission oil, lubricating oil, and other non corrosive liquids can be extracted

Specification:

* 100% brand new and high quality

* Material: Metal + Plastic

* Color: Black

* Rated Voltage: DC 12V

* Rated Power: 60W

* Maximum Flow: 5L/min（Maximum 5L/min when pumping. Viscous liquid flow rate will decrease） 

* Pump Diameter: Approx. 5 cm / 1.97"

* Length: Approx. 16cm / 6.3"

* Cable Length: Approx. 60cm / 23.62

* Clips Length: Approx. 8cm / 3.15"

* Outlet PVC pipe Length:150cm

* Nylon pipe Length:100cm

* Quantity: 1 pc

Features:

* How to use: Start to run the car engine for a while, when oil temperature turns to be about 50 degrees, start pumping oil

* Connect the pump to the power, run it for a while, and observe whether the inlet and outlet is normal

* Open the filler cap,get dipstick out, force the tube into the bottom of the joint, until the tube does not move

* Then put the inlet pipe from the oil dipstick into in end (the tube into the bottom of the tank, the bottom concave place, in order to pump the oil completely)

* As no oil or pumping up very slowly or intermittently, it is generally caused by loose pipes and fittings. You have to install the pipes and fittings again.)

* After oil pumping, remove the tube, and then run the pump for a while, pump the remaining oil inside the pumping clean, or pump water for a while until the pump head gets clean

* If you have not used it for a long time, it may have no suction, then just pour the water in the pump, and run the pump for a few minutes until the air is all out

This pump cannot pump corrosive liquids such as ， but can only pump non-corrosive liquids such as engine oil, water, lubricating oil, etc.

What is included:

1x Oil Pump

1x 11mm Outlet PVC pipe

1x 6mm Nylon pipe

Note: This pump cannot pump gasoline and diesel, only non-corrosive liquid