Description:
This Cooling relay wiring kit takes all of the guess work out of installing a single or a dual fan setup.
Perfect for the professional auto mechanic,the weekend machanic and for all DIY'ers.
It will make installing any Electric Fan(s) to your cooling system project that much easier
About the Relay:
Relay is an electrical control device that usually used in automatic control circuit.Like starter kills, power door lock/actuator control, change a low current output to high current,
add ignition/accessory outputs,control motors/other electronics.
It is also suitable for automobile used for control, alarms, horn, headlight and more.
Pins 85 & 86 - are used to turn 'on' the relay. You need a positive (+) and negative (-) power source to
turn on the relay.
- Pin 85 - is usually negative (-)If you are intending to run 30 amps continuously, you could remove the spade contacts from the connector,
carefully open the crimps securing the wire to the contact and recrimp/solder 10 gauge wires to it.
Also, you can use 6.3 mm female connectors
to connect directly to the relay pins. The relay should be good for 30 amps.