[TYPE D]-High Freq-220V High Voltage Power Supply Module,Power Supply Module Std.

DANGER! Lethal Potentials Present
THIS MODULE CONTAINS DANGEROUS, HIGH VOLTAGE POTENTIALS. USE CAUTION.
DO NOT TOUCH ANY PART OF THE MODULE WHEN IT IS WORKING.

Notice:
The "HW10W"/"10W" etc. marks on the PCB is the serial number,it does not mean this is a 10-Watt ouput only module.This module can output 15W max with no problem,We may change this mark to "HV15W" in the next batch of the PCB to avoide this misunderstanding.

Product Change Notification in V1.0:

Description:
1. This is a newly designed HIEND high voltage power converters;Can accept 9~18V DC in,and output up to about 220V DC,range set by an on-board 3296 trimmer resistor(For Lower DC input you get lower MAX DC output).
2. Have increased the frequency up to about 120kHz to get more noiseless output to suit for the Audio amplifying circuit etc;
3. High quality transformer on-board to low down the noise;
4. It contains an /ENABLE pin to turn the convert on/off,and can be controlled by an regular logic signal,like a MCU's GPIO PIN.
5. No audible noise;
6. Standard 0.1"(2.54mm) pins, easy to be used, can use DuPont-Wires etc.

Tips:
1.Please control the input current in <=1A for the low heat working state,if need more power output,you can increase the input voltage;
2.Please use high quality and stable input DC source,make sure the max input voltage is not over the max range;
3.For the heavy loader,the max output voltage may get a little bit drop,it's normal;
4.If needed,you can add an LC filter on the audio board by yourself;
5.Do not go over power/Heat/voltage/current, will damage the MOSFET or IC or Transformer on board.

Typical Usage:

For driving Audio AMP/NIXIE Tubes/Magic Eye Tubes and other applications requiring high DC voltage.

Typical Parameters:
(For reference only)

Input: 12V DC;
Output: 200V DC
Max Power Output: 15W;(For working under 10W for 24*7 condition,the module got almost no heat.)
Max efficiency: 92.6%;
Output setting: Adjustable with a single trimmer resistor;
Module size: 48mm*42mm*13mm;

Simple test by myself:

By using a KTEC 12V/1.5A AC Power Adapter which is for my WD USB HARD DRIVER,and driving a regular FSL 15W 220V~240V E14 light bulb(which I bought for my refrigerator early),the results shown below:

Input:12V;
Output Voltage:190V with the light bulb turned on;
Output Current:53mA;
Power output:~10W;
Efficiency:88.6%;
No audible noise;
Worked fine under 24*7 condition,the Max MOSFET temperature is about 38℃(degree C)-(Room temperature is 28℃ ).
--------------------------------------------------------------------------------------------------------------------------------------------------------

Note:

We may not be able to provide extra technology support!
We may will change the Outlook/Circuit/PCB/Components without notification!
It's DIY stuff,sometimes may need 3~5 working days for assembling and heat testing!


Contains:
1PCS power supply module,ready to go.(without any tubes,without power adapter,without wires;)

Payment methods:

We ONLY accept PayPal on eBay selling, other payment is not acceptable.
Please PAY within 7 days, or we'll re-selling the item.

Shipping:
We ship to American via ePacket Delivery with tracking number;
We ship to Other countries/locations via International Economy Package with tracking number;

For shipping to  The United Kingdom or Australia or Russian Federation, we strongly recommand you update to the EUB(express);
Price for updating to the EUB(express):
For shipping to The United Kingdom or Australia: +5.99usd;
For shipping to Russian Federation: +3.99usd;

China Post Office tracking website:

Shipping time:
10-20 working days for ePacket Delivery to the U.S.A.(normally you will receive it in about two weeks), depends on the destination location;For other far locations may need more days.

Please note that International Economy Package can ship to the World wild with low price,but the transport speed is very unstable,mail delay is very normal,shipping to far locations may cost over 30 days,sometimes the cargoes will be stuck in the airport for over one month(especially in the special meeting time,it happened before).
Please understand that we can't control the mail speed.If the mail delayed,please be patient.
If you wanna save your time,add extra money for updating to the EMS.

We ship to your PAYPAL Verified Address only;
Any import tax or charges should be paid by the buyer.

=====================================================================================
The data shown below is for reference only!!!

Absolute Maximum Ratings

Electrical Characteristics (DC Parameters)

Notes:
1.Module contains input reverse polarity protection.
2.Module contains short protection circuit via current limitin
3.Do not go over power,it's dangerous!!!

Tips:
About the Economy Mail to the World Wide:
The International Economy Package is mailed to the destination country by CHINA POST and delivered via the local postal system. Delivery time is usually between 14 to 30 business days.

Usually delivery status is traceable on the post office website of CHINA POST and(or) the destination country post office website.

China Post Office tracking website:

But sometimes,on those web sites,you can track 0 info or just the info that when the goods are transported inside CHINA. Especially shipping to the far locations,just be patient.
For the Economy Mail,if we got the Tracking number for you,it means that the goods are already in the post office.
If you have not received the goods in 30 days,notice us,we will ask for the detail tracking information via the local post office.