Parameter:
Model: TS-VU003
Working voltage: DC/AC 12-18V
Output current: <50mA
PCB Size: 74x50mm
Meter calibration function: support
Backlight power output: 2V-12V 100mA (automatically adjust the output voltage according to the backlight voltage of the VU meter)
Model input: ≤5V rms
Tungsten lamp, LED backlight voltage: automatically adjust the output voltage according to the backlight voltage of the VU meter
1. Power supply: AC/DC 12-16V. To distinguish between AC and DC input terminals.
2. L, G, R: Two-channel input terminals of the driver board, which can be connected to the audio of audio source devices such as mobile phones, computer sound cards, pre-amplifiers (the signal is the signal that can be heard by the earphone), and the attack amplifier output terminal to get the signal. L, G, and R correspond to the left, ground, and right channels of the audio source device respectively, if the input is a mobile phone, computer sound card, preamp, etc. audio source. Please turn the DIP switches 1 and 3 to the "ON" port. If the input is the output terminal of the power amplifier, please turn the DIP switches 2 and 4 to the "ON" port, the signal will be compressed by 11 times. Note: The DIP switch cannot simultaneously switch 1 and 4 to the "ON" port.
3. The adjustable potentiometer "100R-V" is used to adjust the brightness of the backlight of the VU meter.
4. Adjustable potentiometers "50k-1" and "50k-2" control the beating amplitude of the pointers of VU meter 1 and VU meter 2, respectively.