Golde Windback Sunroof Sliders (Cable Ends)
VW Golf & Jetta mk1
This listing is for a single slider, you will need two if you are going to repair both the left and right cable in your car
If you compare your cable end to the above pics you will be able to determine if they fit or not, the cable end is the same on a lot of makes, the difference usually is the orientation of the slider and the length of the cable
A lot of the original factory sunroof cables only had plastic ends on them and were prone to break, these are machined from solid brass and will outlast the plastic versions by far
The sliders come with the holes predrilled, the large hole for the hinge pin is 4.5mm in diameter, the original pins are actually 5mm in diameter but I have noticed after installing these on some old cables that the original pins have worn a little or have some corrosion around them so I now make them with the 4.5mm hole to allow for this, if you remove your pins and they are in good shape you will need to widen that hole to 5mm to get the pin in
The slider is actually the same for both sides, when you install the hinge and the spring retainer from your old cables you need to make sure you get the orientation correct as that is what determines which side the cable will fit on
I can also supplies these with the cable (upto 1.8m in length) and the spring retainer installed, please see my other listings or message me for further details
If you have any questions please feel free to contact me