Description :
Product Name:4 Axis 3.0 Control Board/ 3 Axis 4.0 Control Board
Product Specifications:4 Axis/ 3 Axis
Package Size:185mm*115mm*55mm
Package Weight:300g
Product Size:122mm*87mm
Product Weight:150g
Operating System:Window/Linux/Mac
Interface Type:TypeC
Supply Voltage:DC24V- 5A
Software Support:Candle/LaserGRBL/LightBurn/USG
4988 Driver Features
--Low RDS (on) output
--Automatic current decay mode detection/selection
--Mixed and slow current decay mode
--Low power dissipation synchronous rectification
--Internal UVLO
--Cross current protection
--3.3 and 5 V compatible logic power supplies
--Thermal shutdown circuit
--Ground short circuit protection
--Load short circuit protection
--Five optional step modes: Full, 1/2, 1/4, 1/8 and 1/16
DRV8825 Driver Features
--The maximum current is 2.5A.
--the highest support for 32 subdivisions.
--4 layer PCB board, better heat dissipation performance.
--the chip internal resistance is smaller, lower heat, better heat dissipation.
--Size: 1.5mmX2mm (same as 4988)
--Driven current: 2.5A
--Subdivision: 1, 1/2, 1/4, 1/8, 1/16, 1/32
--Manufacturing process: SMT placement machine manufacturing, non-manual welding, higher yield, more stable performance
--Double y-axis, all-round use,XYZ or XYY.
--Stepper drive setup subdivision.
--Integrated 3 A4988 drivers, directly connect to four wire stepper motor.
--Support Laser or Spindle.
--Support 12V, 5V with TTL and without TTL laser.
--Adjustable driver subdivision.
--Support the xyz limit switch, probe interface.
--Support external Offline Controller(Optional).
--A4988 can be replaced with 8825 driver.
--ARM32-bit MCU control board, running faster, the maximum no-load speed reaches 40000mm/min, better algorithm optimization, less vibration when the machine moves at high speed, and more stable performance;
--X/Y/Z/A four-axis drive, Y-axis dual drive. Support for rotary axis
--The control board power supply and line number circuit use optocoupler isolation, the entire control board is safer, more stable, and has strong anti-interference ability
--External 300W/500W spindle
--Split design, control, drive and expansion boards can be replaced
--limit switches, 5V/12V/24V constant voltage pins
--Can be connected to a high-power driver
--Stepper drive subdivision adjustable
--Can connect 775 motor/3pin laser 4pin laser/offline controller. Reserve 24V, 12V, 5V power output ports to facilitate the expansion of various functions
--PWM/TTL software to adjust laser power
--Support USB flash firmware, firmware upgrade is more convenient
*Type C data cables have all been replaced with white.
Connect to 300/500w spindle motor
Connect to 775 spindle motor
Connect to external drivers