Compatibility:
1998-2006 VOLKSWAGEN BEETLE
2008-2009 VOLKSWAGEN BORA
2006-2009 VOLKSWAGEN EUROVAN
1999-2006 VOLKSWAGEN GOLF
1999-2006 VOLKSWAGEN JETTA
Specification:
Condition: 100% Brand New
Replacement: Directly Replacement
Material: Plastic
Number Of Pins: 5
Color: Black (As picture showed)
Warranty: 1 Year
About the MASS AIR FLOW (MAF) SENSOR:
WHAT does a MAF Sensor do?
The Mass Air Flow (MAF) sensor measures the amount of air flow entering the intake manifold using a heated grid or wire. The PCM uses this signal primarily for fuel control.
WHERE are these sensors located?
The Mass Air Flow sensor is located in the intake ducting after the air filter.
INSTALLING the replacement MASS AIR FLOW SENSOR(MAF):
1. Position MAF sensor in the vehicle. Make sure the airflow direction indicated on the sensor is toward the engine.
2. Install sensor to air duct seal(s), if so equipped, on the replacement MAF sensor.
3. Connect the MAF sensor to the throttle body air cleaner ducts. If the sensor mounts directly on the throttle body, install and tighten the mounting screws to 10 ft-lb. DO NOT OVERTIGHTEN!
4. Position clamps over the air duct/MAF sensor connections and tighten. Replace the clamps if necessary. (NOTE: For the MAF sensor to work properly, the sensor/air duct connections must be airtight.)
5. CAREFULLY plug the harness connector lead into the MAF sensor.
Package Included:
1x Mass Air Flow Sensor/Meter