BACK COVER MAY BE JUST BLANK WITH NO WRITING AS PICTURED OR THE ORIGINAL BACK CONDITION HAS NEW CASE PERFECT LOGO BUTTONS in excellent clean.CONDITION
1999 - 2004 Honda Odyssey 5 Button Keyless Entry Remote Fob - OUCG8D-440H-A
VERY IMPORTANT THERE ARE TWO THAT LOOK THE SAME HOWEVER THEY BOTH HAVE DIFFERENT PART NUMBERS AND FCC ID NUMBERS ONLY ONE WILL WORK DEPENDING ON OPTIONS AND WHERE IT WAS MADE SO MATCH UP THE FCC ID NUMBER WITH YOUR WORKING REMOTE, IF YOU PURCHASE THE WRONG ONE IT WILL NOT PROGRAM. PLEASE DO THIS TO ADVOID A RETURN
Remote is Factory OEM Honda Keyless Remote. PLEASE CALL DEALER PARTS DEPARTMENT AND HAVE YOUR VIN NUMBER READY. ASK THEM FOR THE CORRECT REMOTE AND YOU WILL GET A PRICE, THEN ASK FOR A PART NUMBER. THEN YOU WILL KNOW THE CORRECT ONE FOR YOUR CAR FCC ID: OUCG8D-440H-A MODEL G8D-440H-A OE Part # 72147-S0X-A02 5 BUTTON REMOTE THIS REMOTE IS IN WORKING CONDITION WITH NEW BATTERY
Programming Instructions Obtain all remote transmitters for this vehicle and read the instructions prior to programming. Entering programming mode will erase all previously programmed remotes for this vehicle. You must have all remotes available for programming, including working ones. Enter vehicle and close all doors Each of the following steps must be completed within five seconds of completing the previous step. If you take longer than five seconds or make a mistake, you must start the entire procedure over.Insert the key into the ignition, hold one remote in your left hand with additional remotes close by. We recommend taking remotes off the key ring to perform the procedure.
When the instructions say to press the LOCK button, you should press the LOCK button on the remote for approximately one second then release it. Perform each of the next three steps in order, then repeat all three steps two more times for a total of three times each.
1. Turn the ignition to the ON position, marked II.
2. Press the LOCK button on the remote.
3. Turn the ignition to the OFF position, marked I. (Do steps 1-3 three times) Next, turn the ignition switch to ON position, marked II. 4. Using the same remote, press the LOCK button again. The door locks should cycle, indicating the vehicle has ENTERED programming mode.
5. Using the same remote, press the LOCK button again. The door locks should cycle, indicating the vehicle has PROGRAMMED that remote. If you have other remotes to program, then repeat step 5 with each additional remote one after another. Step 5 must be completed within ten seconds for each additional remote. You may program up to three remotes. 6. Turn the ignition to OFF. Test all remotes. If your remote has a trunk button you'll will need to hold that button down for several seconds for that function to operate.