Swivel mount for AKG CK61/63 capsules with NBob V2 active connectors.  3D printed by Shapeways, then assembled and shipped from Pagosa Springs, CO.  Comes complete with hardware and hex-key.  Microphones and shockmount are not included.

The following lists the capsule spacing and base angle for each model.  To adjust the capsule angle, simply loosen the hex bolts with the supplied hex-key and rotate the clips to the desired angle.  Then, re-tighten the bolts.  Angles are marked in 5° increments.

DINA: 17cm @ 90°

ORTF: 17cm @ 110°

DIN: 20cm @ 90°