Top off your engine with these carburetor air/fuel installation kits. Complete installation kit includes mounting hardware.

Kit Includes:

• (1) Edelbrock 1413 Performer 4 Barrel Carburetor, 800 CFM, Electric Choke
• (1) 14 Inch Fully Finned Round Air Cleaner Set, Black Aluminum
• (1) Edelbrock 81263 Fuel Line Kit for Performer/Thunder Series, 3/8" Barb
• (1) 1-1/2" Liquid-Filled Fuel Pressure Gauge, 0-15 PSI
• (1) Carburetor Stud Kit, 1-3/8 Inch

Edelbrock 1413 Performer 4 Barrel Carburetor, 800 CFM, Electric Choke

• Edelbrock Performer Series carbs have proven themselves to be easy to tune with great drivability
• Whether you need to replace an aging stock four barrel carb or are looking for a performance carb to top off your hot rod, the Edelbrock Performer Series four barrel carbs are the best choice for performance and value
• All Edelbrock products are proudly made in the U.S.A
• Designed and calibrated for maximum street performance with most Performer RPM, RPM Air-Gap and Torker II manifolds and with Performer manifolds on large cubic-inch engines
• Includes an electric choke and detailed instructions
• Ford/Mopar throttle adapter arms sold separately

Features:

• Bolt-on-and-run performance right out of the box
• Two-piece design means no gaskets below the fuel level for leak-free operation
• Electric choke
• Smooth throttle response throughout the power band
• Uses metering rods to transition between circuits - rods can be changed in seconds without carburetor removal or draining fuel
• Float levels are factory set; adjustments are rarely needed
• Change jets, adjust floats & replace needles/seats without draining fuel or removing carb
• Lightweight all-aluminum body is compatible with gasohol and blended fuels
• Includes both timed and full vacuum ports for ignition advance

14 Inch Fully Finned Round Air Cleaner Set, Black Aluminum

• Fits 5-1/8" carb neck
• 14" diameter
• 3" tall paper filter
• Black polished aluminum air cleaner
• Features a full finned top
• 5" mounting stud included
• Carburetor base provides a 1" drop from the neck of the carburetor

Edelbrock 81263 Fuel Line Kit for Performer/Thunder Series, 3/8" Barb

• For Performer And Thunder Series Carburetors
• Provides a clean and custom plumbing solution
• Single Feed
• Without Filter
• 3/8" Barbed Inlet
• Black steel

1-1/2" Liquid-Filled Fuel Pressure Gauge, 0-15 PSI

• Appropriate fuel pressure is important for adjusting your fuel system to achieve optimal performance, which means an accurate pressure gauge is equally important
• Built for superior precision
• Liquid filled and available for carbureted and fuel injected applications
• 0-15 PSI
• 1-1/2" diameter

Carburetor Stud Kit, 1-3/8 Inch

• Easy installation/removal of carb plates
• Includes zinc plated steel studs, nuts and washers
• 1-3/8" tall

(PDF)

Comes with:

• Metering Jets - Primary .113, Secondary .101
• Metering Rods -.071 x .047
• Step-Up Spring - orange (5" Hg)