Offered for sale is 1 custom seller refurbished Snap on IM32, 3/8" drive butterfly impact wrench. I installed a NOS Snap on anvil and new hammer pins. I complete the refurbishment with a tune up kit and full air motor refurbishment. I bought a NOS Snap On leather cover, stretched it to fit and then oiled it to prevent water from from shrinking the leather. The previous owner engraved 3 letters on the tool housing and I did as much polishing as possible to minimize them. I also provide extra throttle valve plugs, a gasket and 3) anvil ring kits.

Special noteworthy Conditions:

I do recommend using 2 or 3 wraps of plumbers teflon tape on the last few threads (but not on the first 2 threads) of your male threaded shop air fitting to avoid bottoming into the inlet bushing threads with your shop air fitting to capture a proper air seal.  Teflon tape can shred and clog the bushing debris screen when not carefully used. Avoid using air fittings with less than 1/4" ID and make sure to obtain 90 psi air pressure to the tool with air hoses that are not cracked internally.  If you have any performance problems with any air tool always check the air inlet bushing debris screen first to make sure that the tool is not being starved for air supply.

I don't specifically offer a warranty on my tools sold on ebay.  That is because there are some shops with wet and dirty air, deteriorating air hoses or shop air piping that will destroy tools.  There are also some people who push the limits of their tools much harder than what a manufacturer recommends when they should be using a larger drive tool.  If you do have a tool performance issue that is my fault I recognize that you will need my support to make corrective repairs.  I have not had customer complaints from ebay store sales with my rebuilds or new tools sold.  I make every effort to correct any existing tool issues and verify my work when I rebuild a pneumatic tool.  I have sold repaired air tools overseas on ebay without any issues. 

NOTE: Snap on rated this IM32 impact wrench for a bench test range to 150 foot pounds. Buying this tool means that you understand by this disclosure not to expect your tool experience to be any different than I claim here that it would be with abusing this tool. By example, using an IM32 for taking lug nuts off pickup trucks in a tire shop would be a very stupid use of this tool and accelerate it's demise or failure by breaking parts. Pushing high torque limits on this tool will break hammer pins and damage anvils. 

I ship this tool weighing 3 pounds using a USPS Priority Air Mail with an ebay label and tracking to all 50 states and Puerto Rico.