Gasoline Engine Tacho Adapter RPM Signal Sensor For Car Vehicle Truck Boat Yacht
Gasoline Engine Tacho Adapter RPM Signal Sensor For Car Vehicle Truck Boat Yacht
Model: GR01
1.Cable Definition
- RED: Power Supply 12V DC
- BLACK: Power GND
- BLACK/BROWN (1.6m): Input Signal Cable
- BLUE: Output Signal (fixed 4pulses/round rpm ratio)
- BROWN: Switch Control Cable
2.Configure Steps:
- 1)Connect Switch Cable to enter in setting mode
- 2)Find the Ignition Coil of your Gasoline Engine, normally it’s close to Spark Plug, which can be easily found from your engine/car/vehicle user guide.
Wrap the input signal cable 5~8 round across the ignition coil cable, and then tighten like below:
- 3)Power on the Sensor, the LED will stay Green
- 4)Disconnect Switch Cable, the LED will still stay Green and calculate the detected pulse from engine
- 5)Connect Switch Brown Cable and Disconnect again, the LED will flash
- 6)The sensor output Pulse signal with fixed Tach RPM ratio 4pulese/round, which means it will output 66.6Hz when 1000RPM.
For example, if the input frequency is 100Hz @1000RPM, the sensor will convert the signal and then output 66.6Hz @1000RPM
- 7)How to configure Tachometer?
Please set your Tachometer/RPM Gauge tach RPM ratio to 4 pulses/round, then the Gauge will work properly.