Magnetek model flex 6EX is now replaced with the next generation model 6EX2
Please visit our ebay store for the full product line.This listing is for One hand-held radio remote control Transmitter unit model 6EX2
This 6EX2 transmitter can be used with 6EX2 receivers or 6EX receivers!
If using with an 6EX2 receiver, then you pair it to the receiver.
If using with an 6EX receiver, then you insert your ichip from the old TX and mount it into this new TX unit.
We are Magnetekdirect, a stocking distributor
FREE technical support - we have trained staff offering you support Mon-Fri, 9-5 EST.
This new 6EX2 transmitter can be programmed to control your 1st Generation 6EX receiver, or it can be programmed to control the new 2nd generation 6EX2 receiver unit !!
To program the new 6EX2 transmitter to control a 1st Gen 6EX receiver:
(1) remove I-chip from old 6EX transmitter, and install in new 6EX2 transmitter
(2) set 1st 8-positions of the dipswitch on the 6EX2 transmitter to match the 8-position Function-dipswitch in the 6EX transmitter (fyi; there is no RF channel dipswitch on the 6EX2 transmitter, it reads the RF channel from the I-chip)
We are a full service shop - offering "Free" pre-programming of the Serial number and RF channel so that the unit is out-of-box ready for you to use, please include a message when you order to include your Sn and RF channel (this information can be found on back of your existing unit).
The new TX unit will be supplied to you as out of box ready, programmed to your Serial Number and with the RF channel preset for you, if you do not provide the Serial Number and RF channel then you will be shipped a blank unit without an ichip for you to program on site.
>> Please visit our magnetekdirect store for
other parts and products <<
Important Note: the part number #0-TXC-27, flex model 6EX is now replaced by manufacturer part number FLEX-6EX2-TX, the next generation flex model 6EX2
