Descriptions & Features:
★Used To Aid In The Installation And Sizing Of 4L80E And 4L85E Turbine Shaft Seals. Available For All Input Shaft Lengths.
★Easy To Use, The Size Adjuster Prevents Improper Seal Installation And Damage. Prevent Deformation During Installation.
★Similar To Kent-Moore J-38736, Atec Trans-Tool T-2974 & T-2974-M. This Tool Will Install Small And Large Seals.
★It Comes With a Universal Seal Extender For Both Ends, a Small End Seal Resizer And a Big End Seal Resizer.
★Made Of High Quality Durable Steel, Durable.
Specifications:
Material: Steel
Packing Size: 15*10*8cm
Gross Weight: 0.65kg
Net Weight: 0.5kg
Package Includes:
1X For Gm 4L80E/4L85E Tool Kit
Instructions:
1. Properly Remove The Old Seal, Making Sure To Remove All Seal Debris From Each Groove.
2. Lubricate Grooves, New Seals And Tools With Trans Gel.
3. First Unroll The Small End Seal To The Correct Id.
4. Center The New Seal In The Groove And Press Lightly With Your Fingers To Ensure The Seal Is Inserted Into The Groove.
5. Slide The Small Size Adjuster Onto The Seal First Using The Long Tapered End, This Will Ensure The Seal Is Gradually Seated Into The Groove. Note: Using The Short Tapered Edges First May Cause The Seals To Roll Out Of The Grooves And Permanently Damage Them! ! !
6. Let The Sizer Set The Seals For At Least a Minute, Then Now Flip The Sizer Tool Over Using The Short Tapered Side To Make Sure Both Seals Are The Correct Size.
7. Repeat The Same Steps For The Big End, Making Sure All Grooves, Seals And Tools Are Properly Lubricated With Trans-Gel Prior To Installation.
- We maintain high standards of excellence and strive for hundred percent customer satisfaction. Feedback is very important to us. We hope that you contact us immediately before you give neutral or negative feedback, so that we can address your concerns. It is impossible to address issues if we do not know about them!
