Buy with confidence!  We have sold over 6700 of these kits since we came up with the idea back in 2011.

This is a set of ten stainless steel studs (with an allen drive for easy installation), and stainless steel serrated face flange nuts. They will replace the factory hardware that rust and break on Ford 6.8 liter V10 exhaust manifolds.

NOTE: For clarification, these are meant to secure the exhaust manifold to the cylinder head, you will need one kit per manifold.

 These engines are notorious for needing the exhaust manifolds and hardware replaced. Why use steel hardware that is just going to rust again? We not only assemble these kits from our stock, but some of us here have also installed them with great, long term results. It is always a good idea to use anti-seize on an application like this.

HERE ARE SOME OTHER HELPFUL ITEMS FOR YOUR 4.6, 5.4 AND 6.8 LITER FORD:

EXHAUST MANIFOLD STAINLESS BOLT KITS........... EXHAUST MANIFOLD STUD TAP & DRILL..........Y-PIPE STAINLESS BOLT KITS......... COIL PACK STAINLESS BOLT KITS.

You can find them on our ebay store under the heading "Ford 4.6, 5.4 and 6.8L Items"

A NOTE ABOUT QUALITY / MATERIAL: We won't insult your intelligence by claiming we have the best kits on ebay, in order to do that we would have to constantly purchase and laboratory test other people's products. What we can tell you is, we have more than 40 years experience as a Metric fastener distributor, coupled with more than 20 years in automotive repair and engine building experience. With that said, you will receive the exact same hardware we have tested, installed, and continue to use on our own vehicles.