Saniflo Depot | Upflush Toilets

This SaniBEST Upflush Kit Includes

  1. The SaniBEST macerating bathroom pump
  2. White toilet bowl (size: elongated)
  3. White toilet tank
Retail Price: $1,748.00
Our Price: $1,497.61 + no tax + free shipping (20-30% total savings)
UPC#s 013, 087, 005

Available Product Combinations 

SaniBEST Benefits

The SaniBEST is a system that is used to install a complete bathroom up to 15 feet below the sewer line, or even up to 150 feet away from a soil stack. The  SaniBEST pump is designed to connect with:

  1. This  SaniBEST Upflush Toilet
  2. Any Sink
  3. Any Shower
  4. Any Bath

SaniBEST Installation

The  SaniBEST is simplicity itself to install; there are just four connections.

  1. The macerating/pump is connected to the spigot of a horizontal outlet toilet. 
  2. The toilet tank is connected to the water supply. 
  3. The macerating/pump is connected to the small diameter discharge pipe work. 
  4. The macerating/pump is connected to the electrical supply. 
Then optionally connect the discharge pipes from the sink, shower and/or bath.

SaniBEST Function

The inside of the SaniBEST is comprised of a pressure chamber, which starts and stops the unit, and the motor, which drives the stainless steel cutting blade and the pump.  When the flush is activated, the water flowing into the SaniBEST activates a micro switch in the pressure chamber, which in turn starts the motor.  The motor is sealed for life in an oil filled enclosure.  A common spindle/shaft drives the impeller and the blades.  The moving parts therefore are kept to an absolute minimum.  Water and organic waste matter, enter the chamber and are reduced to slurry as the blades rotate at 3600 RPM.  The reduced solids are picked up at the bottom and the impeller mounted beneath the motor ejects the waste.

The unit pumps the effluent upward to 18 feet and/or 150 feet horizontally (with gravity fall).  Once the water level in the container goes down, the micro switch deactivates.  A normal operating cycle for the SaniBEST takes about 7-9 seconds depending upon the discharge pipe run configuration.

In addition, the SaniBEST will also discharge gray water from a variety of other sanitary fixtures such as: a sink, a bath/shower, a urinal and even a washing machine (indirect connection).  When adding a bathtub/shower, a base will have to be constructed.  This base should be made out of a 2” x 6” (minimum) or 2”x 8” (recommended) on edge, to allow for the installation of a P-trap and the required 1/4” per foot gravity flow towards the pump unit.

The wastewater from other sanitary fixtures is discharged into the SaniBEST via two 1½-inch inlets on either side of the housing.  The discharge elbow on top of the SaniBEST can be rotated 360 degrees depending on the discharge installation.  A non-return valve (included in assembly) prevents back flow into the unit.

This unit has been designed with a vent connection on the lid.  All plumbing codes require connection to a vent system.  Please note that the vent system should be a two-way air vent.  The use of mechanical vents, air admittance valves or similar devices are not permitted as these are considered one-way air vent systems.

The SaniBEST unit must be connected to our rear discharge toilet.  It is highly recommended for the grinder to be connected to a Ground Fault Interrupter (GFI) circuit.

The Sanibest has been certified to American and Canadian Standards.  Macerating standard; US: CSA Certified & IAPMO (UPC) listed - ASME A112.3.4, CA: Macerating Standard CSA B45.9. 

SaniBEST Water Conservation

The water closet the SaniBEST is connected to, uses much less water than a regular toilet, it uses 6 liters (1.6 US Gal) of water per flush.

SaniBEST Product Specifications

PART NUMBERS

UPC#s 013, 007 and 005

DIMENSIONS (PUMP ONLY)

H10" x W21" x D9"

H26cm x W53cm x D23cm 

MOTOR

Induction Motor

No carbon brushes or gears.

Tested over 30,000 cycles. 3600 rpm. 

ELECTRICAL SUPPLY

110-115V; 60Hz; 15 Amps 

Usage 9 Amps

DISCHARGE

Horizontally to 150 ft (50m)

Gravity Fall on Horizontal installations: 1/4" per ft 

Pumps vertically to 18 ft (5.5m) 

DISCHARGE PIPE DIAMETER

3/4"

21mm 

CONSTRUCTION MATERIALS

Polypropylene, C.R.P., Stainless Steel, Neoprene

MAX TEMPERATURE

104°F

40°C 

NORMAL RUNNING TIME

7–9 secs

subject to installation pipe run 

WATER PER FLUSH

1.6 US gal

6 liters

VOLUME

7.35 gal/m

27 l/m 


Options

Bowl Size


REGULAR   ELONGATED
BOWLRound FrontElongated Front
TANKVitreous china tankVitreous china tank
HEIGHT (SEAT)16-3/4 inches16-3/4 inches
DEPTH (OVERALL)     26-1/2 inches28-1/2 inches
VOLUME1.28 gpf1.28 gpf
WARRANTY1 year on china1 year on china
ADA COMPLIANTNoYes

Extension

      INSTALLATION - Visible        INSTALLATION - Behind Wall
EXTENSION PIPE NEEDED?          NoYes

About Us

  • Top rated, authorized SaniFlo dealer
  • Over 30 years’ experience
  • We provide our customers:
    • Full Phone Support
    • 4 Year Warranty

Contact Us

We have SaniFlo experts waiting and all questions,during business days, are answered within 2 hours!