Great News!  for USA buyers ,Ship from USA warehouse, after payment, within 3-5 days for receiving products! No taxes from customs, no damage, better service, please don't hesitate!

This item includes: 

                                4 PCS Nema 34 Stepper Motor with Single shaft 1232oz-in holding torque,

                                4 PCS Stepper Driver DQ860MA with 7.8A replacing MD882,

                                4 PCS Power Supplies for  350W,60VDC,

                                1 PC Breakout Board& 1 PC Cable for free offering  

                             

    The Breakout Board is offered to you for free to buy this item above, so that you can set this kit up, and work in better condition.

1, Stepper Motor

Technical Specifications

Part No.:                      WT86STH118-6004A

Frame Size:                  NEMA34

Step Angle:                  1.8 degree

Voltage:                       3.6V

Current:                       5.6A/phase

Resistance:                  0.6 Ohm/phase

Inductance:                  6.5 mH/phase

Holding torque:            8.7N.m            1232oz-in

Rotor inertia:                2700g-cm2

Number of wire leads:  4

Weight:                        3.8 kg

Length:                        118mm

Note: Nema 34 Stepper Motor with 1232oz-in holding torque on  single shaft, the diameter for motor shaft is 14mm.

 

RED            A+

GREEN       A-

YELLOW    B+

BLUE          B-

Please tell us if you need Double shaft or single shaft, we can manufacture both for you. If you need Double shaft, please tell us your requirements for length of front and rear shaft, as well as the diameter. So that we can offer you the quite good products, thanks!

 

2, Stepper Motor Driver  DQ860MA

Introduction,Features and Applications

Introduction

The DQ860MA is  an economical microstepping driver based on patented technology of Wantai Motor .It is suitable for driving 2-phase 4-phase hybrid stepping motors .By using the advanced bipolar constant-current shopping technique ,it can output more speed and torque from the same motor,compared with traditional drivers ,such as L/R drivers .Its 3-state current control technology allows coil currents to be well controlled and with relatively small current ripple,therefore less motor heating is achieved.

Features

◆Low cost and good high-speed torque

◆14 selectable resolutions

◆Supply voltage up to +80VD               

◆Suitable for-2-phase and 4-phase motors

◆Output current up to 7.8A,5.6A rated current

◆Dip switch current setting 8different values

◆Optically isolated input signals

◆Pulse frequency up to 200KHz  

◆Automatic idle-current reductiOn

◆Small size  (107*97*48),Weight:500G

3, Power Supply 

350W,60VDC,5.9A 

 4, Breakout Board

 

Description:

  • Built in DB25 male connector.
  • DB25 Output Pin:P1,P2,P3,P4,P5,P6,P7,P8,P9,P14,P16,P17.
  • DB25 Input Pin: P10,P11,P12,P13,P15.
  • DB25 GND Pin: P18-P25.
  • Power supply: +5V DC.
  • Built in C-class Optical-coupler.
  • High quality with Surface-mount Tech.

 We ship worldwide!

 

 

        Our Products are mainly used in robotization, Spinning Automatization, Printing, Packing, Medica   Machine, Make-up Equipment, Communication,    Household Appliance, Water Pump, Milling Machine, Engraver Machine, CNC Routers.. etc automatic equipment of various trades.