The Uni-Clamp has been designed to progressively pull heavy hits on
structural repairs as well as lighter repairs such as creases on body
panels. Pull creases on heavier panels as well as sheet metal parts on
all automobiles and light trucks. Can be used with a pulling tower or
any other source of applied power.
A series of up to 11 studs are welded closely together on a panel. The
Uni-Clamp is then tightened onto all of the studs and the pull is made.
As the dent is removed, one section will always come out first. The
screws securing the studs on that repaired area are loosened eliminating
any more pulling on the area. By tightening and loosening the screws,
the pull can be controlled to only pull on the low spots of the dent.
The end result is a flat, even repair.
- Weld 11 studs where required using the <1045 Eliminator Side by Side Adapter and any Uni-Spotter Stud Welder
- Use screw wrench (included) to tighten up each stud
- Release studs as the dent is removed. Pull only the low spots
- Use narrow 5 hole side for tighter areas, or 11 hole side for larger pulls
- ABTM part number: 3334
NOTE: Studs not included.