1. PLEASE NOTE THAT WHEN YOU HAVE YOUR CYLINDER BORED OUT YOU MUST HAVE THE PISTON FIRST SO THEY CAN MEASURE THE PISTON THEN BORE THE BLOCK! If your machine shop tries to bore the block before they have the piston, go to a different machine shop because they do not know what they are doing.
  2. FIRST: You take your block to a machine shop, they will tell you what size to purchase
  3. SECOND: Then you order your piston, then take your piston to the machine shop so they can measure the piston, add in the tolerances and bore the cylinder. I've done this for along time and this is how you do it if you want it done right
  4.                  10hp K 241  The measurements are not for machine shop use. The machine shop must have the new piston to bore the cylinder.

    Standard cylinder bore........3.251"

    +.010 .................................. 3.261"

    +.020....................................3.271"

    +.030....................................3.281" 

    5.
  5. We are one of the largest aftermarket supplier of rebuild kits for Kohler K and M series engines in the World.
  6. We sell the same rebuilds that almost all engine rebuilders use.
  7. We are able to sell so much cheaper because we buy in huge quantities.
  8. We sell what we use and have sold world wide and sell to tractor pullers with 100% pos. feedback on these high quality kits.
  9. Over 50,000 piston and rings sets sold on ebay
  11. This aftermarket piston and ring set is for the 10hp K241.
The suffix after the the model number does not matter, that means for example: all K241 engines, such as K241A, K241S, K241AS, K241AQS and so on no matter what the suffix is.
 You will receive one new piston, chrome rings, wrist pin and 2 clips.

I purchase Stens and Rotory and have 100% Positive feedback on all my rebuilds

We sell new items only and any NEW parts can be exchanged for different sizes but not returned for money