ULTRA LIGHT 70% LIGHT
TRANSMISSION 30% DARKER TINT
1 x ROLL 3m x 76cm
WINDOW
TINTING FILM FOR CARS, BOATS & BUILDINGS USE WITH KIT
FITTING INSTRUCTION:
IMPORTANT:
The film must be separated from its
transparent protective layer
this is best done with 2 small
pieces of scotch/adhesive tape/ sticked
on both sides of one of the corners
of the film and this will reveal its adhesive side,
please apply it on your window with
plenty of soapy water on the glass,
then press with the plastic tool (to
avoid scratching the film please
do not press too hard with the
plastic tool or better wrap it in some cloth).
Thanks
1. Clean window inside and out with
soapy water. NO AMMONIA
2. Cut film pattern on outside of
glass. LINEAR SHOULD FACE OUTSIDE
3. Trim film to fit on outside of
window
4. Spray a light film of water on
glass and film
5. Peel film apart from backing on
inside of window. Use two pieces of transparent tape to separate film from
liner
6. Spray adhesive with soapy water
solution
7. Place film on INSIDE of window
8. Spray film with soapy water
solution and squeegee firmly
9. Trim film with new sharp blade,
leaving 1/16” gap around edges
10. Spray film with soapy water solution and squeegee firmly
11. Drying time 3 days in full sun
Thanks for Looking!
The United Kingdom sets minimum light level requirements for vehicle window tint. Please make sure you follow these requirements: https://www.gov.uk/tinted-vehicle-window-rules