eBay

Hardware Philosophy Brass Radial Washers 1.2" - Set of 10

Transform your hardware ensemble with our chic washer, embossed with center radiating lines. Versatile for pairing with any brass-fitted accessory.

Set of 10: Each washer measures 1.18"W x 1.18"H x 0.18"D (30mm x 30mm x 7mm); Hole diameter is at 0.19" (50mm)
Solid Brass: Made from high-quality brass, this washer adds a touch of sophistication and refinement to any furniture or architectural project. Its sleek design seamlessly complements a wide range of hardware, from traditional to modern, making it a versatile choice for enhancing both residential and commercial spaces.
Load Distribution: These washers feature a circular design that effectively distributes loads across a wider surface area, reducing the risk of damage to materials and ensuring a secure connection between joining pins.
Fit for Various Brass Hardware Projects: Ideal for architectural restoration, interior design, furniture projects, wooden tables, cabinets, drawers, bureaus, armoires, cupboards, and more.
Care Instructions: Wipe it quickly and lightly with a rag coated with soap and water or rubbing alcohol; Then, rub it with a light-colored oil such as olive oil; To remove some of the tarnish and make it shinier, use a thin coating of commercial brass polish; Coat a rag with brass polish and let it dry out for a few hours before polishing to ensure that you don't overpolish

Item AH-1356-3

Installation Guide

Chinese brass hardware is easy to install. The first thing to get familiar with are commonly used joining pins:

	Soft Joining Pins Made of bendable metal tongs that can be bent and hooked into the opposite side of the wood. Normally used for pulls, handles, and other items where lateral pulling strength is required.
	Hard Joining Pins Made of thick metal tongs that can be bent but not hooked around the opposite side of the wood. Normally used for bolts and hooks where vertical strength is required.
	Nailing Pins Made of one long, straight metal spear that is nailed into the wood. Like hard joining pins, they are used for bolts and hooks where vertical strength is required.
	You'll need a few basic tools: Needle nose pliers (recommended - but any type of pliers will do.) Hammer Drill bit (same width as the pin you're going to install) Power drill

	For this example, we've chosen a classic fish pull to install.
	Drill a hole the same width as the pin. In this example we're drilling a 1/4" hole for a 1/4" wide pin.
	Assemble your piece of hardware and insert in the hole.
	Using the needle nose pliers, bend the tip of the pin over so that it's pointing towards the wood.
	Making sure that the display side of the piece is pulled tight, nail the end of the pin into the wood.
	Nail the pin flat.

	In this example we've chosen a cabinet face plate to install.
	Drill a hole the same width as the pins. In this example we're drilling a 1/4" hole for a 1/4" pin.
	Assemble your piece of hardware and insert in the hole.
	Using the needle nose pliers, spread the pins flat against the wood.
	Making sure that the display side of the piece is pulled tight, nail the pin flat against the wood.

Note: Unlike soft folding pins there's no need to hook the end of the pin into the wood - just nail it flat.

	In this example, we've chosen a cabinet strip pull to install.
	Drill a hole the same width as the pins. In this example we're drilling a 3/16 " hole for a 3/16 " pin.
	Assemble your piece of hardware. Hammer the nailing pin into the pilot hole. We recommend using a piece of wood as a buffer to avoid damaging the hardware.
	It's usually a good idea to file or clip the end of the nailing pin down if it is protrudes out the opposite side of the wood (this can be done before installation as well).
	Nailing pins are as strong as very thick nails.