·          1st Quality Fiberglass, Silicone Bonded to an Aluminum Alloy outer skin

·          Designed to provide maximum heat reflectivity while also protecting from chemical, oil leaks & spills, dirt, road grime and other underhood hazards

·          Pliable enough to be shaped to fit the tightest bends.

·          Better than heavy silicone tape, sleeves are lightweight, easy to install and easy to remove

·          Reflects over 90 % of Radiant Heat

·          Rated for Extreme Heat:

§  Continuous exposure to 1100 degrees

§  Intermittent exposure to 2000 degrees

§  Direct contact to surfaces up to 500 degrees

·          Fireproof

·          Oil Resistant

·          Light Weight

Easy to trim. Slides right over wires, cables and hoses.

For best results seal the sleeves at each end with adhesive foil tape, shrink tube or stainless steel cable ties. Sleeves are conductive always insulate electric terminals that it might come in contact with sleeves. To ensure a proper fit, allow extra room for bends   (for example: a 90º bend in a 3/4" tube will NOT fit in 3/4" I.D. Sleeve, In this case you would need 1" I.D. or higher)

I.D. = Inside Diameter