Fitment and Product Information

Rear High Clearance Shock Mount Kit, For 1984-2001 Jeep XJ

Tired of your rear factory shock mounts dragging the rocks? These new lower High Clearance shock mounts were designed to raise the shock mount a full 3" on an XJ. The new lower mount is relocated even with the bottom of the axle tube, thus drastically increasing ground clearance. This weld on bracket is made from 3/16" steel and includes a new shock stud that will mate with any standard 5/8" ID shock bushing. Although designed for the XJ, this weld on shock mount can be used for any custom application with a tube diameter ranging from 2-1/2" to 3-1/2".

Featured Technology & Benefits:

• 3/16" steel weld on shock mount
• Relocates the rear XJ lower shock mount up 3" to be even with the axle tube
• Can be used on almost any custom application
• Designed to mount to any standard 5/8" ID Shock bushing
• Combine this with the Zone J5022 bar pin eliminator to create the ultimate rear XJ shock set-up

Important Notes!

• Required shocks (specs) may change after installation due to the mounting position changing
• Welding Required

Fitment:

• 1984-2001 Jeep Cherokee XJ

 WARNING: This product can expose you to chemicals including Styrene, which is known to the State of California to cause cancer. For more information go to www.P65Warnings.ca.gov