Suitable for all internal softwood and hardwood floors in both domestic and commercial environments. XL1 provides extremely strong yet flexible coatings offering outstanding chemical and mechanical resistance.

Preparation

Prior to starting the sanding process the floor should be checked for any protruding nail or screw heads and these should either be removed or countersunk. All wooden floors requiring a varnish will have to be sanded. Newly laid floors are sanded to achieve a nice level floor and old floors are sanded to remove existing finishes and to level out worn and heavily used areas.

Sanding will have to be carried out in several grit stages and this will be dependent on the unevenness and general condition of the floor.

Staining

Morrells standard Light Fast range of stains give excellent grain definition and overall colour. Due to this range being spirit based (fast drying), care should be taken on application not to stain too large an area at once as this could lead to a patchy appearance once the stain is dry.

1. Stain should be applied by brush/rag or mohair pad
2. Remove excesses with a clean rag

It is important to remove as much of excess stain as possible so as not to create a film as this could result in poor adhesion of subsequent coats of lacquer.

Stains intended for other uses i.e. decking, fencing, garden furniture etc should not be considered for floors as these will contain water-repelling properties, and therefore water based floor lacquers would not adhere to these stains.