LIMITED NUMBER OF DIE SETS AVAILABLE AT THIS PRICE. This is a coin ring die set of 5 dies and 11 push rods. These dies are made to do the Swedish Wrap Method of making coin rings where you keep pressing the coin down into the die to make a very flat ring. The inside angle is 7 degrees which is much less than that of the fold over reduction dies. Also with 5 different sized dies instead of just 2 or 3, you have more sizes to work with if you do push the coin all the way thru the die. That makes it easier to get the size ring you need. Push the coin thru one die, if you want it smaller go to the next smaller sized die. You will still need a fold over die to start the process of making a ring. The larger die in this set is approximately 1.4" at the top and 1.15" at the bottom. Next is 1.3" at top and 1.05" at bottom. Next is 1.2" at top and .95" at bottom. Next is 1.1" at top and .85" at bottom. Last is 1" at top and .75" at bottom. All of my SW dies are 1-1/8" tall. These dies are hardened and the inside of the die is polished very smooth. The push rods are made out of aluminum so there is less chance you will damage your dies if you press the push rod to far down. The push rod sizes are 1-5/16" 1-1/4" 1-3/16" 1-1/8" 1-1/16" 1" 15/16" 7/8" 13/16" 3/4" 11/16" Auction is for 5 dies, and 11 aluminum push rods. All my tools are made to order and I work Monday thru Friday. So there will be a 1 to 3 day delay in getting your order shipped. Mikestilltools