AUSSIE LOCAL STOCK:   Hi Purity Pigments -Iron Oxides, Titanium Dioxide Rutile, Ultramarine blue. 325 mesh fine powder.   

High purity, Bright-coloured fine powder inorganic pigments with good weatherability, lightfastness, heat and alkali resistance. Strong tinting power, excellent coverage, and fine dispersal.   For use in concrete, screeds & Grout, candle wax, soaps, crafts, epoxy coatings, resin & silicone casting, and in paints. Refer to item image for summary of purity.   Non toxic to skin but harmful if inhaled, may cause irritation to eyes and respiratory tract. Safety and Purity Documents available on request.

For Crack control in Concrete:  See our Reinforcement fibre Listing by copying 143473131609 (Listing ID) into the eBay Search bar

Brightener/Plasticiser 

 Recommended Use

1. DRY SHAKE APPLICATION ON CONCRETE FLOORS AND PAVEMENTS, Applied as a colour hardener on your slab. Blend pigment , white cement and white sand with the following ratio. Pigment ratio of 1g pigment , to 10g white cement. And twice the volume of white sand as white cement.  Mix the pigment and cement first, then add the sand. Apply directly on drying concrete (ensure excess water has dried) or onto stencil. For Two tone application on a stamped concrete floor, the first tone is applied before stamping. Highlights can be applied after stamping. 

2. INTEGRAL APPLICATION IN CONCRETE SLABS, PAVERS, CASTS & GROUT. The Mix Ratio of pigment for integral (internally) coloured concrete is the following:  1.2g Pigment To 10ml Water, 30g White Cement, & 70g Silver Sand. Applied as a Screed up to 70mm thick with reinforcement. Consider our fibre products for crack control and reinforcement.
3. APPLICATION IN RESIN CASTING and  EPOXY FLOOR COVERINGS. 1) Make small test batches with measured weight of pigment and resin until you are satisfied with the ratio of pigments to give you the colour effect you are after. 2) To ensure an even mixture ,Mix in a resin/epoxy into the pigment rather than the other way round. Start with a small amount of resin into the pigment before diluting it with more resin. Add hardener only after the colour is right, and mix again thoroughly. 
4. APPLICATION IN SILICONE CASTING 1) Follow the same recommendations as for epoxy, but add the pigment to Part B (Catalyst for two equal part A+B silicone) bear in mind once you have the right colour for Part B you will need to mix in the same amount of pigment again into Part B before you mix the two parts together to harden.  
5. APPLICATION IN PAINTS :NOTE: TEST & DRY A SMALL SAMPLE WITH YOUR PAINT BASE BEFORE GENERAL USE. 1)  For water/acrylic based Wall paints: mix separately with soft water (50% weight of pigment) first before mixing in with your white paint base. PLEASE NOTE! it Dries Lighter in colour. 2) For Fine Art Oil and Acrylic Based paints add Linseed oil or Acrylic base to pigment a few drops at a time - use a Muller to grind the paste on a flat surface - as you add the oil or Acrylic base.