I've put together (what to me) is a relatively complete bench vise soft jaw clamp for your next suspension overhaul. This is split up into 3 kits. One kit is 2 halves.

Item Specs:

• Two 12x3mm Neodymium magnets per half - quite strong
• Magnets are around 70mm / 2-3/4" apart
• Kits vary a little, but all are in the 135mm / 5-1/4" length range
• 3D printed using PETG filament, a stronger alternative to the commonly used PLA material. Print settings built around strength
• Material is soft enough to not damage the shaft, strong enough to hold it tight.
• Halves snap together with magnets for easy storage (see photo)

Kit #1 Includes:

• 28.6mm / 1-1/4": Fox 36/40 FIT R and 36/40 FIT RC2 damper base-valve body
• 25.4mm / 1": Fox X damper (base valve body) & some rear shock damper cylinders, Fox 32 FIT Terralogic damper cylinder, Marzocchi Doppio air-spring cylinder
• 23.8mm / 15/16": Fox 36 O/B R damper base-valve body, Shimano Saint and XTR front hub thru-axle
• 22.2mm / 7/8": Manitou Cartridge Intrinsic & TPC Cartridge damper cylinder

Kit #2 Includes:

• 21.0mm / 53/64": Shimano 15mm thru-axle front hub
• 19.5mm / 3/4": Fox dampers, base valve body (R, RL, RLC, RLT)
• 18.7mm / 47/64": Fox Gen 3 O/B RL damper cylinder
• 17.5mm / 11/16": Fox 36/40 FIT RC2 damper cylinders, TALAS Lower Air Shaft
• 16.7mm / 21/32": Fox FIT 32 RL & RLC damper-cartridge body

Kit #3 Includes:

• 15.9mm / 5/8": Fox TALAS IFP Shaft
• 15.0mm 19/32": Marzocchi SFA/ATA air-piston shafts
• 12.7mm / 1/2": RockShox Vivid rear shock damper shaft, DHX RC4
• 10mm / 25/64": Fox and Marzocchi forks (damper and piston shafts)
• 9.53mm / 3/8": Unsure of what models, but a common size
• 9mm / 23/64": RockShox Ario/Bar/Monarch air-shock damper shafts
• 8mm / 5/16": Fox, Manitou and Marzocchi forks (damper and piston shafts)

Above fitment is by no means complete as so many other models are not listed and will use some of these sizes. Also, please note that actual compatibility is for you to confirm before purchase. These values looked correct when I made these, but suspension evolves so quickly I cannot guarantee fitment based on the descriptions.

If you have a desire for a custom version with your desired sizes, send me a message and we'll work out a deal.