The Intona high speed isolator supports USB full speed 12Mbps and high speed 480Mbps and provides galvanic isolation between the USB host and device and protects the device from power shocks and avoid ground loops that can be very troublesome in audio.

It supplies the connected device with 300mA nominal current, 500mA max. This version support 1kV signal and power isolation and 15kV ESD protection.

Download Data Sheet

Specifications

  • Provides galvanic isolation to the USB bus
  • Compliant to USB 2.0 Hi-Speed (480 MBit/s)
  • Backwards compatible to Full Speed and Low Speed
  • Isolation withstands up to 1kVRMS
  • Advanced ESD protection (15kV IEC Air-gap Discharge)
  • Works out of the box, no drivers needed
  • Transparent to host and device: wide compatibility to all operating systems, embedded systems and devices
  • Works also with hubs and extenders
  • Supports all USB-specific transfers and modes
  • No additional round-trip latency
  • Powered by USB bus, no separate power supply
  • Ultra-quiet power rail isolation, linear regulation
  • 300mA nominal (500mA max.) output current on isolated side
  • Connectors: host-side USB-B; device-side USB-A
  • Status LED for each port showing bus state and speed
  • Impedance controlled high-speed circuit design
  • National compliances: FCC, CE, RCM, ICES-003
  • IP 54 ABS housing
  • Dimensions: 135 x 90 x 46 mm
  • Color: black
  • Made in Germany
Note: USB Cable not included

Model: 7054 / 7054-DK (dark)