Aladdin No 23 Burner : Complete burner assembly for No 23 Aladdin Table lamp *USED CONDITION*. Generally good condition , but there is some discolouration to part of the burner assembly and wick and flame spreader both show signs of having been used.  Otherwise complete and operating correctly so far as  I can see. Fits number 23 Table lamp , but may fit other models with the same screw fitting between burner and base font.

Valor 171249 Burner Cone. Not absolutely sure of the heaters this fits , but believed to be : 12E, 15, S.20, 32K, 207. Please measure carefully against your old item before ordering. overall base diameter 3 1/2" /9cm . Top hole 1 5/8" /4.25cm. 3 of these available at time of listing. The first is in near perfect condition with no dulling of brass finish, the others are more discoloured { see photos } Best stock will be sent out first. Packing box is not included as this is being used to store more than one item. Old part number 980509

Valor 172438 Gallery Washer. Flat fibre washer for sealing between gallery and tank on some models. Measure approx 3"/7.5cm outside diameter : Inside diameter approx : 2 1/4" /6,4cm : Width approx 3/16" /4mm . Thin washer approx 1-2mm thick. Suits  Models with screw in gallery Numbers 37, L125, 207, 210, L210, Minor 64

3mm Gallery Washer.  Original Valor Round section rubber gallery washer approx 3mm diameter. Outer diameter unstretched approx 3" /7.5cm  :

Universal Burner Coil Number 3  : Hattersley Nickel Chrome Burner Coil for Radiant Paraffin Heaters - Fits under the radiant Mesh { See above} . Because these are flexible , they can be fitted to virtually all Radiant dome style paraffin heaters., No inner bag, and coil has some distortion due to handling / poor storage, ( See Photos) but performance should not be affected.

Radiant Chimney Complete - Complete replacement chimney for Radiant Type Heater. So far as I am aware this is Valor , and in a Valor box marked with part number 151480, although I can find no reference on spec sheets to this number. Full chimney complete with mesh dome and inner burner coil. Overall diameter around 4 1/8" /10.5cm Height of main body approx 4" /10cm excluding dome , 5 1/4" /13.5cm including dome. Generally sound condition , although there are some tarnish marks on the outer surface of the chimney { see photos}  

Unbranded Radiant Mesh Type 1  : Replacement wire mesh dome for Radiant style paraffin heaters. Unbranded . Base diameter approx 5 1/4" /13 cm edge to edge . Approx 1 1/8" / 3 cm High. Suits heaters with plain unedged  mesh dome. A little scruffy from storage but still essentially intact.

Unbranded Radiant Mesh Type 2  : Replacement wire mesh dome for Radiant style paraffin heaters. Unbranded . Base diameter approx 4 1/2" /11.5 cm edge to edge . Approx 1 3/8" / 4 cm High. Suits heaters with plain unedged  mesh dome. A little scruffy from storage but still essentially intact.

3" Flat Wick x 10" Length : Length of plain cotton wick , unbranded. 3" / 7.5cm wide , sold as an approximate length of 10" /25cm. Lengths are cut from a large roll , so can be sold as longer lengths. The last 2 lengths have been the outside of the bulk roll , so are generally quite grubby , but this should not affect performance.

Mica Type 1 : 6 cm Square : Clear Mica panel for Paraffin heater chimney , 2 1/4" /6cm square with no fixing hole. Generic Clear Mica panel suitable for a number of paraffin heaters, including many Aladdin 2" burner heaters.

Mica Type 2 Shaped : Clear Mica panel for Paraffin Heater chimney . 2 3/8" / 6cm x 3" /7.5cm Rectangular panel , with uneven "corners" cut off at the top. Off centre Fixing hole . The last few of these have some marks , and the very last one is still intact but has had the corner bent over at some point. Better stock will be sent out first. Valor part Number 119579  For Valor 64 series Boiling Stoves , including Valor 64 Minor . Some items have original Valor Packaging.