Charger Not Included

Stay up to date and learn more @RNoksDesigns

Also in need of battery mounts? Check out my other listing: Click Here

Milwaukee M12 Charger Mount/Holder
  • Place charger on mount base plate, insert "C" shaped retention clip and the charger will stay in place (neodymium magnets in clip and base keep the clip in place)
  • Charger can easily be removed from mount to take to job site
  • Only one hand needed to install/remove battery from charger
  • Wall, ceiling, table mountable with 4 screw holes (built for countersunk screw heads)
  • Cable management clips (8 clips around edge of base to keep your cord tidy)

Other Tidbits
  • All are designed and made in USA by yours truly, 3D printed.
  • Made with PETG filament which when compared to the commonly used PLA, offers improved strength and also high heat resistance (PLA has a poor resistance to heat and can cause deformation).

Silly Fine Print
  • Designed for genuine Milwaukee M12 12-volt charger #48-59-2401, will not work with other models. 
  • Charger not included