Charger and Battery Not Included

If you only need (or want more) battery mounts, I sell those in a separate listing# 143672242299 Click Here

Learn more and keep up to date on developments at @RNoksDesigns

DeWalt DCB102 2-Battery Charger Mount/Holder

• Place charger on mount base plate, insert the two "C" shaped retention clips and the charger is "locked" in place. Neodymium magnets in clip and base keep the clips in place.
• Ferrite Bead holder can be placed on right or left side (+1 points if you knew that cylinder on the end of the cable was called a ferrite bead as I had to look it up!)
• Charger can easily be removed from mount to take to job site
• Only one hand needed to install/remove battery from charger
• Wall, ceiling, table mountable with 4 countersunk screw holes
• Custom designed and manufactured by myself

Optional DeWalt 20v Max Battery Mount/Holder - Available in Locking and Non-Locking Versions:

1. Locking Version - Requires pressing of battery button to release. Battery can't fall out even if upside-down.
2. Non-Locking Version - Just slide battery off clamp, no need to fiddle with battery button. Perfect for wall mount in a shop where gravity will always keep battery in place

Battery Mount Specs:

• Fits all DeWalt 20V and FlexVolt 60V Batteries.
• Wall, ceiling, table mountable with 2 screw holes per mount. Sized for up to #8 screws.

Other Tidbits

• All are made in USA by yours truly, 3D printed.
• Made with PETG filament which when compared to the commonly used PLA, offers improved strength and also high heat resistance (PLA has a poor resistance to heat and can cause deformation).

Silly Fine Print

• Designed for genuine DeWalt DCB102 charger, will not work with other models/off-brands. 
• Charger and battery not included (only charger wall mount included).
• DeWalt is a registered trademark of Black & Decker (U.S.) Inc.