TF means Taper Flat End TR means Taper Round End.
TC means Taper Conical End FO means Flame Ogival End
SF means Straight Flat End SO means straight Ogival End
EX means SPecial shape BR means ball Round.
BC means Ball collar Type DI means Double Inverted Cone.
SI means Single inverted Cone WR means wheel Round Edge
CR means inlay preparation CD means Childern's dentistry.
S means short shank SS means super short shank
Notice:
- For dental use only.
- Non-sterile.
- Insert the shank into the handpiece according to the instruction of the handpiece manufacturer. Inserthion should be the full length.
- Before use, run the instruments to make sure there is no descentering. If the instruments become bent, be sure to remove them from any further use.
- Please always use spray. A plentiful water supply is necessary to maintain long-lived performance and also to prevent loading and pulpitis.
- Handle with care not to put excessive load. Pressure should be 20p-50p for all instruments with diameter up to 023.
- Use below max. allowable R.P.M of each instrument, see chart above, to avoid a possibility of being injured due to breakage.
- Avoid levering, tilting, twisting and jamming motion. Do not work with a pulling motion.
- Wear a safety glasses and/or facemask to protect from being injured.
- Practicable for using auto-clave. Do not use high pressure steam sterilizer which heats more than 200 degree drying process.
- After using, follow appropriate treatment as the medical waste.