Waterslide Transfers for Scaleauto F1/ Scalextric, Footwork FA13
These are a home designed and made to measure sets of decals to transform a Scalextric Sally Ferries (or similar) F1/F2 single seater C693 into a Footwork FA13 from 1992.
Alternatively, these will also fit the Scaleauto Formula 90-94
This set depicts the car driven by Michele Alboretto
Instructions for use:
- Clean the surface where the decal is to be applied. Smooth and glossy is best.
- Cut out your decal carefully, as close to the design as possible. (printed using waterproof ink)
- Note: some decals have a colour mask around them which can be cut into.
- Place the decal in warm water for 20 secs or until it just moves on the backing paper
- Transfer to surface using tweezers and position carefully, using something like a wooden toothpick.
- Roll a cotton bud over the decal to squeeze out any water. Only do this a couple of times.
- Once dry, its recommended to apply a coat of Microscale Micro Gloss or something similar.
Auction includes a set sheet of transfers only. The car is not included. Thanks for Looking!