Custom hand made in the USA. Brand new design by Extremeblaster XB06 tunable exhaust system out yet ( no re-jet required). Pipe is available in Chrome or all black powder coat finish at the same cost. Slip on shorty muffler with 3" stainless steel tunable disk system fitting 2000-2002 ZX6R, 2005-2009 Kawasaki ZZR600 stock header pipe (side exhaust mount with header back to tail pipe is a singe unit and must be cut to slip on extremeblaster short pipe). The Extremeblaster XB06 also can be purchased with a slash cap and 6) additional 3" plates (see below) for a more sport look and further quiet the exhaust to achieve smooth running capability similar too stock exhaust. The extra plates can be added to return to full power mode (but will get louder). 

10% off introductory offer for photos and feedback after installation. Message me after install for this refund offer.

XB06 incorporates high efficiency disk technology producing a clean burning exhaust with better low end torque, response and top end horsepower with the same or better fuel economy over the stock design. No additional fuel needed from a fuel controller or jet change to compensate for the shorter pipe. This is a tuned exhaust system with a careful balance of low end torque and top end power delivery. Disk pipe delivers awesome acceleration like adding 2-3 teeth to your rear sprocket and delivers deep low RPM tone that is not excessively loud at low/mid-range RPM like most short aftermarket pipes and meets SAE 92-100db std at idle/5k rpm. Pipe is ready to bolt on to stock header and runs great with stock carburetors or Dyno jet kits (no jetting required). Incredible superbike tone not found on any other aftermarket pipe today. For a sound clip of this type of exhaust please go to you tube and search lvgsxr extremeblaster exhaust XB08SS. For more detailed information regarding this product please see extremeblasterexhaust.com

Please see my Ebay feedback for more customer information regarding this product.

*note* this item is brand new, never used.

Slash cap with 6) tunable plates and t-bolt clamp - $35.00

Shipping: Please allow up to 5) days to ship this made to order item. This exhaust is not ready made to deliver. Shipping in US 2-3 days, 6-10 days Internationa

New for 2014! All hi-temp black powder coat parts (including clamps) with weather resistant coating.
This powder coating type is designed for optimum performance in harsh environments specific to motorcycle exhaust and other high temperature applications in outdoor environment. It has superior heat and corrosion resistance and has been tested to automotive specifications and meets or exceeds standards of performance for exhaust and muffler coatings. Heat resistance in excess of 1100 degrees and continuous testing for 48 hours at 800 degrees show this coating to hold its color, gloss and physical integrity at this service temperature. It should be noted this motorcycle exhaust should not exceed 500 degrees.This coating exceeds specifications for salt spray resistance testing. No blistering or rusting from scribe after 120 hours continuous testing. Passed a full battery of corrosion performance tests for automotive applications.

Please check out my new Facebook page at www.facebook.com/extremeblasterexhaust

Please see my new facebook page by searching extremeblasterexhaust in facebook!
Returns - 14 day return buyer pays return shipping. Return pipe unused in the same condition as received (do not run motor through pipe). A 20% restock fee applies to this item due to the made to order custom manufactured exhaust for a particular motorcycle (may not be able to resell for a period of time).
 Shipment will be received Domestically in the US  2-3 days after handling time USPS priority mail. (usually about a week after order for custom exhaust systems)