When buying, you will receive a set of electronic components for self-assembly.
This designer allows you to assemble a device that allows you to exclude large starting starting currents, for example, the charge currents of the capacities of a pulsed power supply, when Power is turned on, which improves the reliability of electronic components of the power supply and reduces the amount of interference for the network.
This device can be used to connect switching power supplies, amplifier power supplies (or other load), with a power consumption of up to 400 watts (without the use of radiators). With the use of radiators, the load power can be increased to 1.5 kW. The device is not intended for connection to electric, synchronous and asynchronous motors.
Specifitation
- Input AC voltage, V 220 (+/- 20%)
- Maximum load power, without radiator, W 400
- Maximum load power, with a radiator, W 1500
- Delay before start, no more, sec 5
- Start duration, sec 0.4-0.8
- Overall dimensions of the board 32x41x35 mm
- Included Instructions in English.
Assembly Recommendations
A properly assembled and soldered circuit does not require configuration and adjustment. Make sure that VD1, VD2, VD3, and VT1 are correctly installed on the board. If you want to use the device with loads of more than 400 watts, we recommend strengthening the
tracks for reliability by applying solder to the tinned places of the tracks where there is no insulating mask. Before switching on, be sure to check the quality of the solder and the absence of short circuits with solder. Since R1 has the property to bask at startup, we recommend that its conclusions be sealed with high quality. To test the operation of the assembled device, take a 60-200W spiral bulb and connect to the device. Connect to the network, wait 5 seconds and observe the increase in brightness of the bulb.
IMPORTANT! The whole circuit does not have galvanic isolation with a 220V, so be extremely ATTENTIVE, avoid touching the board and parts on it during its operation!
To byu another model KITs please see here
