The amplifier portion is composed of a comprometer MOS-FET push-pull output stage that drives the speaker without the current mode amplification. The general amplifier uses a powerful newly developed SATRI circuit, with no return/150 to 200 mA for a negative return/about 50 mA, so you can easily drive a large speaker while saying a near field. It seems to be a pretty good guitar amplifier, and famous musicians are on tour of overseas performances.
Gain (volume) can be controlled, so you can enjoy the music directly without a preamplifier, without a preamplifier. In addition, since it is a variable resistor, the gain of the amplifier changes at the volume position, and the more the volume is reduced, the lower the gain, so you can enjoy a high -quality sound without miscellaneous sound even when the volume is low. There are two input systems: the RCA terminal on the back and the vonjack on the front panel. You can connect a mobile player or smartphone to input the front desk, so you can connect to the CAP-1001 immediately after returning home and enjoy high-resolution music as it is.
CAP-1001 also has a headphone terminal, so you can use it as a headphone amplifier. Also, when listening to music with headphones, the volume comes out of the speaker is set so that it is smaller.
The power supply of the CAP series uses a DC power supply for portable and noise measures. CAP-1001 requires DC24V for power amplifier, but you can use it outdoors if you use a 24V battery. If you use a battery, you will be able to perform the best performance without being affected by noise.
Maximum output | 6W+6W (1%distortion), 8W+8W (10%distortion) |
---|---|
Distortion (1kHz) | 0.01W: 0.04%, 0.1w: 0.04%, 1w: 0.1% |
S/N ratio | -111db (the same gain) |
Frequency characteristic | 5Hz ~ 50kHz (-3db) |
Phase characteristics | 45 ° (50kHz) |
size | W130 X H45X D180mm |
weight | 500g |
power supply | 24v1a DC |