110V/220V 60W Electric Hot Knife Ribbon Rope Cutter Melting Industrial Cloth Fabric PVC Nylon Heated Cutting Tool Kits

Voltage:110/220V,
Frequency: 50/60Hz
Power: 60W,
Intermittent operation:1/4 min,
Power cord length: 2.5m
Weight: 950g

Features

1. Avoid direct short circuit between cutting heads.
2. Clean cutting heads with enclosed wire brush.
3. Please make sure the blade is connected to the cutting material before blade heats up.
4. It is so easy and economical to use, you will wonder how you did without it. Uses include Webbing, Elastic, Cord, Ropes, Nylon and Synthetics.
5. 60-watt power; It is so easy and economical to use and it has wide use. Uses include Webbing, Elastic, Cord, Ropes, Nylon and Synthetics.
6. 'R' type cutting blade included, 60-watt power, Quick heat up time and lightweight and durable.
7. Long life span and can non-stop run.Much lighter and easier for shipping with low freight cost.

Application

1. Cut the rope with diameter 2cm, and the webbing, with fine cutting edge, no disperse.
2. Attached with the cutting foot, the hot knife cut the synthetic fiber cloth without backup under the cloth, seal the cutting edge as well; cut the seal line on the bag.
3. Especially good for cutting sail cloth, awnings and filter cloth.

Caution

1. Always operate the hot knife in well ventilated space.
2. Never burn off the excess residue on the hot knife blade. The blades will over heated and be warped.
3. Only operate hot knife when it is in contact with the insulation board.
4. Keep hot blades away from skin, clothing and other flammable materials.
5. Allow blades to cool before handling. Hot knife may cause injury or burns to exposed surfaces.
6. If the temperature inside the tool is too high, the unit will get hot and the internal thermal protectors will turn it off, after it cool, the hot knife will operate again.