Material: plastic, alloy
Size: 5.4 × two point nine × 1.4 (cm)
Function:
Note (the remote control can be used if it is not scrollable),
The remote control cannot be used even if it has a rolling code (the rolling code is a chip with a confidentiality agreement)
The latest IC programming code prevents accidental removal.
This is a fixed frequency remote 433MHz clone, which is used to replicate 99.99% of common fixed and learning code remote.
Clone up to 2 remote control signals from 2 different remote controls
The remote controller is widely used, mainly for remote control of electric retractable doors, remote control railings, remote control roller shutter doors, garage doors, remote control LED lights, remote control fireworks igniters, remote control of passenger doors, anti-theft alarms, electric door alarms, MP3 motorcycle anti-theft alarms, etc., and also can be used for four-channel radio controllers for automobiles (with remote control roof outside and remote control products outside), heating systems, home automation, etc.
Parameters:
Working voltage: DC12V (built-in 27A12V battery)
Working current: 10mA
Radiated power: 10mw
Transmission frequency: 433MHZ
Transmission distance: 50-100M (in open area, the sensitivity of receiving equipment is negative 100dbm)
Encoder type: fixed encoding. Learning code
Accessories list: 1 x copy remote control
Other instructions:
How to program:
1. Delete the history code of the copier.
Press the A and B buttons continuously until the LED flashes 3 times.
Leave key B (press and hold key A), slowly press key B 3 times, and the LED flashes.
Leave the A key to clear the code gap.
If the code clearing is correct, press any key briefly. The lamp will not flash.
If the indicator light flashes, the release process of short pressing any button is wrong. Please retry the sharing process.
2. Copy the code from the original station.
Place the cloned remote control side by side with the original remote control. Make sure they are in contact.
Press and hold a button on the original remote control and a button on the clone remote control until the remote control flashes continuously on the clone LED.
The red LED will flash three times quickly, then stop for one second, and then flash steadily.
Release both buttons. Programming succeeded. Copy other buttons in the same way.