- Condition: 100% new
- Color: Silver
- Material: Metal
- Item included:
1 x Single Lever Engine Control
1 x Set Mounting Hardware
- Suitable for:
All types of boats with outboard, inboard or I/O power, gas, or diesel
All 33C style and other engine control cables
-
This Is Aftermarket Replacement Item But Not Genuine
- Note:
1) All dimensions are measured by hand, there may be small deviations.
2) Color may vary slightly due to the color setting of each individual monitor.
Feature:
1) According to the original factory specifications.
2) Perfect match for the original one.
3) Dual action, throttle and shift in one lever.Operate both throttle and shift for 1 engine.
4) Great for any type of boat with outboard, inboard or I/O power, gas or Diesel, very smooth shifting and throttle.
5) Pull-out handle disengages shift for throttle only warm-up.
6) The boat throttle has smooth shifting and throttling to be labor-saving and to lower the difficulties to operate. It uses built-in friction to avoid throttle creep.
7) The control system is mainly used for yachts, fishing boats and other water vehicles throttle and gear control, using a single handle to achieve control of the throttle and gear.
8) The neutral position is done by pulling out the hand levers 30 degree.
Open the throttle Step As Follows:
1) Remove the lever.
2) Unlock the throttle and pull the flexible shaft.
3) Remove the swivel bracket.
4) Loosen the two (2) hex head screws at the link mechanism and remove the linkage. Make sure that the shift arm engagement teeth position is not changed.
5) Push the throttle arm toward the housing and rotate it 180 degrees until it bounces back.
6) Use the hex head screw to fasten the connecting rod mechanism to the desired position.
7) Insert the swivel bracket into the appropriate hole.
8) Re-install the push-pull flexible shaft and handle bar.
