Features:
Description:
·
Classic & elegant design light up your bathroom’s
practical decoration
o
The universal Trip Lever bathtub drain stopper brings the most efficient
method to your life - Modern looking and easy installation.
o
It has a metal construction that will endure the rigors of everyday use.
·
EASY TO INSTALL: INSTRUCTIONS:
1. Remove old screws and overflow plate
from the bathtub.
2. Carefully detach plate from linkage
(A) by removing cotter pin (B).
3. Attach linkage to new overflow plate
(C). Align screw holes (S) on your new overflow plate and thread screws into
place.
4. Remove the old stopper. There are
several types of drain stopper, all of which can be removed very easily, with
the stopper in the "open" position by turning the stopper
counter-clockwise until the stopper unthreads from the old one.
5. Remove worn drain body by inserting
plier handles (F) or similar tool into drain, engaging cross members and then
turning counterclockwise to the unthread drain from the bathtub. Remove worn
drain gasket on the tub (G) if needed.
6. For easy installation, remove the
stopper (D) from new drain first, and then rolling a piece of plumber’s putty
in your hands that are about the same thickness of a pencil. Wrap this
underneath the lip of the new drain body (E), making sure that it reaches all
the way around.
7. Check the size of your bathtub drain
hole.
- For 1-5/8” hole, remove
bushing/adapter (H) from new drain body (E);
- For 1-1/2” hole, keep the
bushing/adapter (H) on the new one. Firstly place the new gasket (G) if needed,
and then the drain body (E) in the drain hole. Slowly turn the drain clockwise
to catch the first few threads of the drain elbow underneath the tub.
**Careful not to
cross thread!***
8. Once the drain body is carefully
threaded into the first few threads of the drain elbow, use the plier handles
(F) or similar tool to turn clockwise to tighten. Warning - Do this
carefully, so as not to squeeze the
gasket underneath the tub out of place. The connection needs to be tight to
prevent leaks, but tightening it too much risks cracking the tub
or breaking the seal.
9. Remove any excess plumber's putty,
and install the tub stopper, if needed. Then plug the tub and run a bit of
water, checking for any leaks.
Package:
·
Trip Lever bathtub drain kit with drain*1 (1-3/8 in. Npsm (1-5/8
in. - 16 UNC) fine thread exterior)
·
Solid brass bushing*1(1-1/2 in. Npsm x 11.5 in. Npsm adapter
bushing)
·
Trip lever overflow faceplate*1,
·
Screws*2 (1/4 in.-20 x 2 in.),
·
Brass cotter pin*1.