85MM Classical GPS Speedometer 0-160MPH Waterproof for Boat Car Auto Motorcycle
85MM Classical GPS Speedometer 0-160MPH Waterproof for Boat Car Auto Motorcycle
Features:
- Suitable for all vehicles and off-road vehicles
- The signal comes directly from the satellite signal receiver(GPS Antenna), don't need other speed sensor.
- The gauge has the advantages of high precision, quick location confirmation and short start up time.
- IP67 waterproof and dustproof grade
- Reverse polarity protection and anti-fogging performance
- No Stationery Drift
- Stepper motors used for full range of stepping gauges, great feature with its less power consumption, longer life, higher precision, etc.
Specifications:
- Fixing dimension: 85mm(3-3/8")
- Indicating Range: 0-160MPH
- Working Voltage: 12V/24V
- Total Mileage Adjustable, Mileage Range: 0-999999miles
- GPS Blind Area Odometer Compensation
- OverSpeed Buzzer Alarm (Value Adjustable)
- Indication light: LEFT, HIGH BEAM, RIGHT
- Backlight: Red and Yellow available
- Working temperatures: - 40 to 85°C
- Operation mode: LCD display, stepper motor
Installation:
- 1. Cut an 85mm (3 3/8") hole in the panel (II) and allow a clearance of 55mm (2 3/16”) behind the panel to fit the gauge.
- 2. Remove fastening ring (I), insert gauge through the panel from the front. Tighten gauge (III) using fastening ring (I) from the rear.
- 3. Connect cables according to the diagram. Choose either red or yellow wire for backlighting.
- 4. Securely fasten the GPS antenna, preferably outdoors (or inside front windscreen) so that it has a clear view of the sky to pick up satellite signal. Connect the antenna cable to socket in the back of the gauge. Do not cut cable.
- 5. After turning on the power, allow the gauge to search for satellite signal for 1 minute.
Function Select:“ODO”,“BUZZ”
- Press and hold on the button at the back, then turn on the power supply.
- The LCD will show ODO, BUZZ, etc.
- You can select the function after releasing the button.
- 1.“ODO”(change total odometer)
After selecting “ODO”, the LCD will show “5000” (for example 5000 km) , press the button to change the flashing digit from 0 to 999999 to set up the target odometer value.
- 2.“BUZZ”(change overspeed buzzer alarm threshold value)
- After selecting “BUZZ”, e.g. the LCD will show “B 80” (buzzer will be on when speed over 80km/h), press the button to change the flashing digit from 10 to 240 to set up target overspeed buzzer alarm threshold value.
- (Remarks: No.3 function is not ready in the prototype sent to BESTAS, but will be ready in mass production.)
- Note: After setting, you should disconnect both Power+ and GND, then reconnect the two cables , it will save the setting. If you just cut Power +, then it won’t work properly.
Package Included:
- 1x GPS speedometer
- 1x GPS Antenna
- 1x Multi-plug socket
- 1x Installation Instruction