By  AirPrint3D

Please Visit My Shop http://stores.ebay.co.uk/airprint3d  Or Click on Visit Shop in Seller Information Top Right  For Many More Items Thank You Tim. ( Please note every item is printed to order )

You are buying the Magazine Holder Kit ONLY  NOT the Magazine or anything else in the photos.

The short one leaves a 40mm gap when fitted and the Long one fills the whole gap above the plenam.

Disclaimer - This is not a genuine Reximex Product. IT was designed by me and made by me and has nothing to do with the Reximex Company.  3D Printed Onboard Twin Magazine Holder compatible with the Reximex Ixia/Throne MAGAZINES ONLY. Fits .177 and .22 . This Kit Comes in two parts plus 3 self tapping screws. Installed in a couple of minutes. The holder can be fitted with the text either side and the magazines will load in from either side too. Once installed the whole mag holder can slide forwards or backwards so you can position it in the most comfortable position for you. The magazine is inserted round side first with the clear side up. Make sure you line up the protruding line on the bottom with the groove in the holder. Push all the way in until the magazine stops on the small lip on the magazine. The round side sticks out about 15mm depending on which side you inserted it. The other side is virtually flush. To remove push on the round side and then pull out holding the opposite end. Holds up to 2 spare magazines and are easy to load and unload from the holder. Any questions please ask cheers Tim.